1. Pull the position control lever to
lift the implement up after starting
engine
2. Set engine speed at 1500
rev/min.
3. Place the range shift lever in
desired position.
4. Press the brake pedal and
release the parking brake.
4-2. How to drive and how to stop
(1) How to drive
HST type
Position control
lever
Brake
4
4 4
4 - 3
7. If you press brake pedal or push
down cruise control lever, the
cruise control mode shall be
released.
6. If you pull the cruise control
lever up, the tractor will move at
constant speed.
5. Press the HST pedal slowly
forward or backward to move the
tractor.
▶
For HST model, there is a switch to control engine cut-off for driver’s safety. If the
operator leaves the driver’s seat without proper action for safety, the engine shall
be stop automatically. (For further information about seat, see page 3-12)
▶
When you drive HST type tractor, run the engine speed more than 1500 rev/min
for stability of hydraulic system.
▶
Press the HST pedal forward or backward slowly to prevent the sudden start of the
tractor.
Notice
To Next Page
Loading...
Need help?
General
