(2) Replacing Hydraulic Oil Filter
①
①①
① Suction filter
Park tractor on level surface and engage parking
brake and lower
implements and stop the engine and cool down
the tractor sufficiently.
Carefully clean around the filter and set a clean
container under the filter.
Coat clean hydraulic oil on the packing of new
filter and check the packing is
placed well in the groove.
Turn the oil filter counter
Suction filter
Loosen
Tighten
Turn the oil filter counter
with filter wrench.
Turn the new filter clockwise to assemble until
the packing makes contact with the mounting
surface. Tighten ¾ to 1 turn more after packing
contact.
Run the engine at idle and check any leakage.
Check the oil level. If necessary, add new oil.
Replace the HST filter according to the same
procedure of suction filter.
②
②②
② HST filter
Loosen
Fasten
HST filter
5
5 5
5 - 15
▶
Make sure to stop the engine before loosening the oil filter.
▶
If the filter or oil is very hot, it may cause serious burns. After cooling down the
tractor sufficiently, replace the filter.
Warning
To Next Page
Loading...
Need help?
General
