EasyManua.ls Logo

LS tractor J2020H - Every 300 Hour Check; Replacing Engine Oil and Filter

LS tractor J2020H
101 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When engine oil is warm, the
impurities can be drained
completely.
Notice
Drain Engine oil
Run engine for a few minutes to warm oil.
Park the tractor on a level surface.
Remove drain plug of oil pan and drain the oil
completely.
5-7. Every 300 hour check
(1) Replacing Engine oil and Filter
Oil filling port
Drain plug
Oil filter
Replace Engine oil filter
Carefully clean around the filter.
Coat clean engine oil on the packing of new filter
and check the packing is
placed well in the groove.
Turn the oil filter counter-clockwise to remove with
filter wrench.
Turn the new filter clockwise until the packing
makes contact with the mounting surface. Tighten
¾ to 1 turn more after packing contact.
Fill Engine oil
Tighten the drain plugs.
Fill the engine oil as its capacity and check the oil
completely.
Drain plug
5
5 5
5 - 14
level is between “MIN” and “MAX”.
Engine oil capacity : 4.2 L (1.11 U.S. gals)
Check any leakage of the engine while running
the engine for several minutes at idle rpm.
Stop the engine. After several minutes later,
check again the oil level is between “MIN” and
“MAX”.
Install the oil gauge.
Packing
Loosen
Tighten

Table of Contents

Related product manuals