Section #3 - Test Mode and Instrument Tests
Page 29
To conduct the test, refer to the table below. Note that, for display purposes, each
measurement is rounded to whole feet.
If the difference is 25 feet, the displayed simulated speed should be 49, 50, or
51 MPH, and the distance should be 24.5, 25.0, or 25.5 feet.
Action Results
1. Stand on the shooting mark.
2. Power ON the TruSpeed and
press the button 3 times until the
message -d1- appears in the upper
display.
3. Aim to the far target and press the
TRIGGER.
4. Check the display. If necessary, you
may repeat step #3.
5. Press the button. The message
-d2- appears in the upper display.
6. Aim to the near target and press the
TRIGGER.
7. Check the display.
If necessary, you may repeat step #6.
8. Press the button. The screen
displays the simulated speed (50 MPH)
±1 MPH and the difference between
the two distances (25 F) ±6 inches.
If the targets are shot in reverse order, the display is the same,
but the simulated speed appears as a negative number
L
If you need assistance, contact Laser Technology, Inc. See the inside
front cover for LTI contact information.
To Next Page
Loading...