MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Features
Page 4-40Group-Assigned Features
4
12. Under the Overflow Threshold Time heading, do
one
of the following:
■ To keep the factory setting and disable the Overflow Threshold
Time, check the 0 seconds box.
■ To change the threshold, check the second box and write the
maximum number of seconds (1–900) calls wait in the queue in the
space provided.
13. Under the Prompt-Based Overflow heading, do
one
of the following:
■ To keep the factory setting and disable the Prompt-Based Overflow
feature, check the Disabled box.
■ To enable Prompt-Based Overflow, check the Enabled box.
14. Under the Group Type heading, do
one
of the following:
■ To keep the factory setting of no automatic login, check the Auto
Logout box.
■ To change the factory setting from Auto Logout, do
one
of the
following:
— Check the Auto Login box to indicate automatic login for an
extension that should never be logged out, such as a data
extension.
— Check the Integrated VMI box to indicate automatic login for
a VMS that requires special signaling for integrated
operation.
— Check the Generic VMI box to indicate automatic login for a
VMS that does not require special signaling.
15. To specify the number of calls allowed into the group calling queue, under
the Queue Control heading do
one
of the following:
■ To keep the factory setting, check the 99 calls box.
■ To change the threshold, check the second box and write the
number of calls (0–98) in the space provided.
NOTE:
Specifying a Queue Control threshold of 0 indicates that no calls are
allowed into the queue (Queue Control is turned off).
Proceed to the next section, “System Features.”
To Next Page
Loading...
Need help?
General
