EasyManuals Logo

Lucent Technologies MERLIN LEGEND Release 6.1 System Planning

Lucent Technologies MERLIN LEGEND Release 6.1
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #259 background imageLoading...
Page #259 background image
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Data Communications
Page 5-27Assigning Lines/Trunks to Data and Video Stations
5
Assigning Lines/Trunks to Data and
Video Stations 5
The following types of outside lines/trunks are used to make and receive data
calls to and from data stations outside of the system:
â–  Loop-Start (LS). This is the standard line/trunk for homes and small
businesses, and can be used to communicate with outside modem data
stations. Video calls are not made over loop-start lines/trunks. Loop-start
lines/trunks are the least expensive lines/trunks in some areas but have the
following disadvantages:
— They do not protect against glare, a condition that occurs when an
outside call is made at the same time that an incoming call arrives
on the same line/trunk.
— They may not provide reliable far-end disconnect for toll restriction.
!
SecurityAlert:
Toll fraud can occur when loop-start lines/trunks are used with unreliable
disconnect. If the calling party stays on the line after the called party hangs
up, the central office returns a dial tone at the conclusion of the call enabling
the caller to place another call as if it were being placed from your company.
â–  Ground-Start (GS). This line/trunk is preferred for communication with
outside modem data stations. Ground-start lines/trunks provide improved
signaling and reliable far-end disconnect for secure toll restriction. Video
calls are not made over ground-start lines/trunks.
The following kinds of outside ground-start or loop-start lines/trunks can be used
for data communications:
— Basic lines/trunks
— Wide area telecommunications service (WATS)
— 800 service (inbound WATS)
— Foreign exchange (FX)
Ground-start/loop-start lines/trunks connect to ground-start/loop-start jacks on the
following types of modules in the control unit:
— 800 GS/LS
— 400 GS/LS/TTR
— 408 (LS lines/trunks only)
— 408 GS/LS
— 400 (LS lines/trunks only)
— 800 (LS lines/trunks only)
— 408 GS/LS-MLX
— 800 GS/LS-ID

Table of Contents

Other manuals for Lucent Technologies MERLIN LEGEND Release 6.1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies MERLIN LEGEND Release 6.1 and is the answer not in the manual?

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General IconGeneral
BrandLucent Technologies
ModelMERLIN LEGEND Release 6.1
CategoryConference System
LanguageEnglish

Related product manuals