MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Lines/Trunks
Page 3-2Identifying Line/Trunk Jacks
3
Identifying Line/Trunk Jacks 3
Identifying line/trunk jacks consists of the following tasks:
1. Determining which line/trunk jack types are available according to the types
of modules in the control unit
2. Matching incoming trunks to the jacks that support them
3. Designating jacks for auxiliary equipment (if any)
This section contains instructions for completing all of these tasks.
Forms Needed 3
■ Form 1, System Planning
■ Form 2c, System Numbering: Line/Trunk Jacks
You also need the local telephone company’s line/trunk information.
Module Types and Line/Trunk Jack Types 3
The line/trunk jack type is determined by the type of module. Table 3–1 lists the
line/trunk jack types and the incoming line/trunk or auxiliary equipment that can be
connected to these jacks.
To Next Page
Loading...
