Model 3030 & 3030E Series Technical Manual Section 2
Ludlum Measurements, Inc. Page 3 November 2017
Getting Started
Unpacking and Repacking
Caution
The Model 3030 Alpha-Beta Scaler weighs approximately 13.2
kg (29 lb). Take necessary precautions when lifting the
instrument to prevent personal injury or strain.
Remove the calibration certificate and place it in a secure location. Remove
the instrument and accessories (batteries, cable, etc.) and ensure that all of
the items listed on the packing list are in the carton. Check individual item
serial numbers and ensure calibration certificates match. The Model
3030/3030E serial number is located on the back panel, lower left-hand
corner. Most Ludlum Measurements, Inc. detectors have a label on the base
or body of the detector for model and serial number identification.
Important!
If multiple shipments are received, ensure that the detectors
and instruments are not interchanged (particularly in the case
of the Model 3030E). Each instrument is calibrated to a
specific detector(s), and is therefore not interchangeable.
To return an instrument for repair or calibration, provide sufficient packing
material to prevent damage during shipment. Also provide appropriate
warning labels to ensure careful handling.
Every returned instrument must be accompanied by an Instrument Return
Form, which can be downloaded from the Ludlum website at
www.ludlums.com. Find the form by clicking the “Support” tab and
selecting “Repair and Calibration” from the drop-down menu. Then choose
the appropriate Repair and Calibration division where you will find a link to
the form.
To Next Page
Loading...
Need help?
General
