Model 3030 & 3030E Series Technical Manual Section 7
Ludlum Measurements, Inc. Page 22 November 2017
The user is prompted for the password when clicking in the Update button
after changing any of the password protected parameters. If the password
given is correct, the parameters are changed and the instrument is updated.
If the password is incorrect and the user cancels the password prompt, the
previous values for the parameters are restored, with no parameters sent to
the instrument. Clicking in the Start button under the HV Plateau tab will
prompt the user for the password. The password will not be asked for again
until a different tab is selected to allow the user to run multiple plateaus
without having to enter the password every time.
Parameters
The “Update” button at the bottom of the window will save all changes to
the instrument.
File Menu/Load Defaults: This menu item loads the file, “default.cfg,” and
saves the settings to the instrument.
Parameters/Update (Ctrl-U): This menu item is the same as clicking on the
“Update” button.
Parameters/Load from File (Ctrl-O): This menu item loads in settings from
a user-defined text file.
Parameters/Save to File (Ctrl-S): This menu item will save the current
settings to a user-defined file.
Parameters/Reload All Data (Ctrl-R): This menu item will reload all data
from the instrument.
Parameters/Print Parameters (Ctrl-P): This menu item will print out a
report of all parameters to a printer.
Parameters/Password Protect: When this is checked, certain functions
require a password.
To Next Page
Loading...
Need help?
General
