Lumel P30U series - Page 110

111
111
Bit4 20 Defaultsettingsmustberestored
afterfirmwareupdate
Bit3 19 Wrongconfigurationoftheindi-
vidualcharacteristic
Bit2 18 Settings have been read from
fileontheSD/SDHCcard
Bit1 17 Wrong settings file or file is
missing
Bit0 16 notused
4302 r 0...65535 Transducerstatus2.Describesthecurrenttransdu-
cer status.The consecutive bits represent agiven
event.Bitsetto1meansthattheeventhastaken
place.Eventscanonlybecleared.
Bit15 notused
Bit14 notused
Bit13 notused
Bit12 notused
Bit11 notused
Bit10 notused
Bit9 notused
Bit8 notused
Bit7 notused
Bit6 Analog output overflow management
switchedon
Bit5 LED2–Alarm2indication
Bit4 LED1–Alarm1indication
Bit3 notused
Bit2 notused
Bit1 Alarm2relaystatus
Bit0 Alarm1relaystatus