Lumel P30U series - Custom Unit Definition

59
59
 The function selected for the bottom row of the display
isstoredevenafterapowerloss.LCDdisplaycanalsoshowservice
informationaboutthestatusofthetransducer–seetable16.
Table16
Message Description
Restore
Fabr.Par
Factory parameters must be set, e.g. following software
update,transducercanoperate–restorefactoryparameters;
the message does not prevent the measured values from
beingdisplayed,itisdisplayedincycles.
Fabr.Par
done
Successfully restored  transducer factory parameters,
thetransducercan operate,themessagedoesnotprevent
the measured values from being displayed, it is displayed
incyclesfor20seconds.
IP renew
DHCP :
SuccesfullyrefreshethernetcommunicationdatafromDHCP
server;afterthisinformationachivedIPaddressisdisplayed
on LCD display (only for variants equipped with Ethernet
interface)
5.5.4.1. Custom unit definition
 Inthe transducersoftheP30family,apartfromthedefined
standard units, it is possible to define user own unit to be displayed
in the lower line of the LCD display. The maximum size of the unit
field is 5 characters, each character consists of 8 lines which makes
5x8  40fields (registers) thatdefine the unit.Custom unit hasbeen
defined in the transducers by default - the LUMEL logo. In order
todisplaythecustomunit,enter“57”inregister4020orselecttheunit
fromthetransducermenu.
 To define a custom unit, use registers from 4400 … 4440
range.Thefollowingfigurepresentsthemethodofdefiningtheunit.