Lumel P30U series - Writing and Reading Transducer Configuration from File; Storing the Transducer Configuration File; Reading the Transducer Configuration File

61
61
5.5.5. riting and reading transducer configuration from file
 P30U-X1XXXXXX and P30U-X2XXXXXX manufacturing
variantsofP30Utransducersenablestoringandreadingconfiguration
fromthefilelocatedonanexternal SD/SDHCcard orintheinternal file
systemmemory.
5.5.5.1. Storing the transducer configuration file
 To store the current transducer configuration, select
option: 
Service
→
SaveFile
→
Yes
, from the menu
or enter “1” in register 4077. The text file with configuration
will be saved to P30U, folder, file name: P30U_PAR.CON
(section5.8.4.Fig.27.).Anysubsequentsavingtheconfigurationfile
willoverwritethecurrentfile.
5.5.5.2. Reading the transducer configuration file
 Readingthetransducerconfigurationfromfileenablesquick
configuration of the transducer equipped with an external SD/SDHC
card or internal file system memory. The configuration file should be
located in P30U folder and its name should be P30U_PAR.CON.
The file can be generated by a properly configured P30U trans-
ducer or by eCon software  (Modbus RS-485 or TCP/IP). In case of
transducers in P30U-X2XXXXXX manufacturing variant, the file
Fig.19. Algorithm of displaying two values with their units