Lumel P30U series - Changing the Value of the Selected Parameter; Changing Floating-Point Values

22
22
5.4.1. Changing the value of the selected parameter
 To increment the selected parameter, press .
Pressthekeyoncetoincreasethevalueby1.Ifvalueof9isincre-
ased,  the digit will switch to 0. To change the digit, press
.
Press wheneditingthemostsignificantdigittoeditthedigit
signcharacter–press toeditthesigncharacter.
 Toacceptthesetparameter,press
.Theparameter
willbestored.Press
tocancelchangeduringedition.
5.4.2. Changing floating-point values
The change is carried out in two stages (the transition
tothenextstagefollowsafterpressingthe
key.
settingthedotposition(00000.,0000.0,000.00,00.000,0.0000);
The
keymovesthedot to the left,and key
movesthedottotheright.Pressing keywhenchanging
theparametervaluewillcancelsavingoperation.
Settingthevaluefromtherange-99999…99999issimilartothe
integers.
•
•