Lumel P30U series - 5.4. Programming transducer parameters

17
5.4. Programming transducer parameters
 Press and hold for about 3 seconds key
to enter the programming matrix. If access is password protected,
transducer will ask for password. If the entered password is incorrect,
Err.Code
message will be displayed. Correct password enables
access to the programming matrix. Fig. 8 shows the matrix
in the programming mode. Use
or to select
the menu level or navigate the parameters of a given sub-level.
The parameter symbol is displayed at the upper line of the display,
while the parameter is displayed at the lower line of the display.
Press to edit parameter. Press to cancel changing
parameter. Press and hold to exit the programming matrix
and enter the measurement mode. If the transducer remains inactive
for 30 seconds in the parameter programming mode, it will exit the pro-
gramming mode and display the displayed value.