Lumel P30U series - Read-Only Registers

110
110
5... Read-only registers
Table42
Register address
1 bit registers
rite w read r
Range Description
4300 r 0...9999 Firmwareversion100
4301 r 0...65535 Transducerstatus1.Describesthecurrenttransdu-
cer status.The consecutive bits represent agiven
event.Bitsetto1meansthattheeventhastaken
place.Eventscanonlybecleared.
Bit15 31 Lossofcalibrationparameters
Bit14 30 RTC–lossofpresets–battery
error
Bit13 29 Clock – change of winter/sum-
mertime
Bit12 28 No communication with data
memory
Bit11 27 Wrongsettings
Bit10 26 Default settings have been
restored
Bit9 25 Measurementrangeoverflow
Bit8 24 Error in communication with
internalarchivememory
Bit7 23 Archiveparameterserror
Bit6 22 ADCconvertererror
Bit5 21 100%useoftheinternalmemory
archive