Lumel P30U series - Default Settings

62
62
can be moved from one device to another using the FTP protocol.
IncaseofP30U-X1XXXXXXmanufacturingvariants,asingleexternal
memorycardcanbeusedtotransferconfigurationtomultipletransdu-
cersequippedwithexternalSDcardslots.
 Toforceparameterupdatefromfile,switchonthetransducer
whilepressing key.Iftheconfigurationfilecontainsappropria-
tedataandthenewconfigurationisaccepted,thefollowingmessage
willbedisplayedonthetransducerdisplay:
Fig.22. Message confirming successful readout transducer
configuration from file.
Iftheparameterupdatefromfileisforcedandaproperfileismissing
or existing file contains corrupted data (at least one corrupted
parameter),thecurrentconfigurationwillbemaintainedandthefollo-
wingmessagewillbedisplayed:
Fig.23. Message informing about an unsuccessful readout
transducer configuration file.
5.. Default settings
 Default P30U transducer settings have been provided
intable17.Thesesettingscanberestoredusingtransducermenubyse-
lectingSettings Service → Fabr.Par → Yes orviaRS-485
interfacebyentering“1”inregister4055.