To Next Page

To Previous Page

English - 38

8 Press [MENU] to exit the Ethernet OSD menu.

9 Repeat steps 3 ~ 4 and check IP address.

12.

The output image is

not clear with water

ripples

Please refer to the Appendix 1 in the manual to confirm the

applicable power frequency, and reset it according to the

instruction in 5.2 Setting Menu.

13.

The live image does

not display after you

1. Please install the ActiveX control according to the

instruction on the screen

2. If the instruction for installing the ActiveX control does

not appear, please follow the following steps to confirm

and remove the old version of ActiveX control

components, and then re-install the ActiveX control

components.

2.1. Remove the components (Browser IE 8.0/IE

9.0):

Open the IE browser, activate [Tool] → [Manage

Add-ons] → in the drop-down menu of [Display]

at the left side, select [All add-ons]. Then, after

selecting “GFFMpeg Class” and “GoDB Class”,

right-click the mouse to open the menu, and click

[More Info (R)]. Click the [Remove] button at the

bottom left, and then press the [Close] button at

the bottom right to complete the removal of

components.

2.2. Remove the components (Browser IE 7.0):

Open the IE browser, activate [Tool] → [Manage

Add-ons] → [Enable/Disable Add-ons] →in the

drop-down menu of [Display], select [Add-ons that

have been used by Internet Explorer]. Then, after

selecting “GFFMpeg Class” and “GoDB Class”,

press the [Delete] button at the lower right corner.

2.3. After reloading the website, please follow the

instruction on the screen.

Lumens CL510 User Manual

Other manuals for Lumens CL510