Lumens PS660 - I Would Like to Resume the Factory Default Setting (Factory Reset); I Would Like to Reduce the Image Noise (Projector Type)

English - 29
6. Press [ENTER] to activate the image comparison.
7. Press [] or [] to move the images (captured images only)
leftward/rightward.
8. Press [MENU] to return to image thumbnails.
9. Press [SOURCE] to exit.
8.17 I would like to resume the factory default setting
(Factory Reset)
1. Press [MENU] on the remote control or control panel to enter the
setting menu.
2. Press [] or [] to the [Advanced] menu.
3. Press [] to the [Factory Reset].
4. Press [] or [] to select [Yes].
5. Press [ENTER] to activate.
8.18 I would like to reduce the image noise (Projector
Type)
This function enables visual presenter to automatically clear image noise.
The noise is especially obvious when Visual presenter is connected to a
DLP projector. You can use this function to improve the image quality.
1. Press [MENU] on the remote control or control panel to enter the
setting menu.
2. Press [] or [] to the [Setting] menu.
3. Press [] to the [Projector Type].
4. Press [] or [] to select [DLP/LCD].
5. Press [Menu] to exit