Lumens PS660 - I Would Like to Adjust the Volume; I Would Like to Control Projector; Computer-Related Functions

English - 32
8.20.3 Ejecting a SD card
<Note> Turn the power off before ejecting the SD card to avoid
damaging the SD card.
8.21 I would like to adjust the volume
Remote control:
1. Press [VOL+ / VOL-] to adjust the volume.
Control panel:
1. Press [MENU] on the control panel to enter the setting menu.
2. Press [] or [] to the [Setting] menu.
3. Press [] to the [Volume].
4. Press [] or [] to adjust the volume.
5. Press [MENU] to exit.
8.22 I would like to control projector
Control panel:
1. Press [MENU] and [Auto Tune] to power the projector ON
2. Press [MENU] and [Auto Tune] to power the projector OFF
8.23 Computer-related functions
Ensure that the USB cable is connected and the drivers are installed
before using the computer-related functions. Refer to PS660 User Manual
Chapter 4 Installation and Connections 4.3 Connecting to a Computer
and Use Lumens Software and 4.10 Installing application software
8.23.1 I would like to insert a photo in MS-Paint
1. Click [File/From Scanner or Camera] in MS-Paint shown as the bottom
left figure.