English - 14
Chapter 5 Start Using
<Note>: Please adjust it to be suitable for the local voltage frequency of 50/60
Hz. For the frequency in actual use, please refer to the manual (Appendix 1).
1. Remove the lens cap.
2. Pull up the lamp arm to a proper position.
3. Place an object to be displayed under the camera.
4. Press [POWER]
on the
remote control
or
control panel
to power on.
5. Press
control panel
[AUTO TUNE]
button to optimize the image.
You are ready to teach/present.
6. Each time the camera head is moved, press [AUTO TUNE]
on the
remote control
or
control panel
to refocus the lens.
<Note>: According to your request, you can adjust the camera head slightly
to aim at the center of the documents when the anchor of lens was reached.
When using the remote control, aim at the remote sensor on the PS752,
and press the power button.
Once PS752 is turned on, the LED on the control panel will flash a few times
and stay lit. Please contact your distributor if the LED does not light up.
To Next Page
Loading...
Need help?
General
