8
Faceplate
Adapter
Control Facepla
Adapter M
Screws
Control Mounting
Screws
Wallbox
Control
Link
Install Controls and
Activate Loads
STEP 6: Install Controls
After completing steps 4 and 5, mount controls.
Refer to detailed mounting instructions packaged with
each control.
STEP 7: Activate Loads in Bypass
A. Check that the bypass jumpers are in place.
These jumpers protect the switch mechanism from
wiring faults and must be used to check load wiring
when it is installed or modified.
B. Complete load wiring.
C. Turn a load’s input circuit breaker ON.
The loads should energize, the feed breaker should
not trip, and total load current must be no more
than 16 Amps.
D. Repeat ‘C.’ for each circuit with completed load
wiring.
Warning - DO NOT remove bypass
jumpers at this time.
Step by Step instructions for GRAFIK Eye Switching Panel
WALLBOX
CONTROL
CONTROL
MOUNTING SCREWS
ADAPTER
MOUNTING SCREWS
FACEPLATE
ADAPTER
FACEPLATE
CONTROL
LINK
2 position
Bypass
Jumper
LUTRO
R
Link
Power (Pins
Data (Pins
Circui
Valu
V
IE
V
ALU
5
4
3
2
1
Load
Control and Zone
High End (optional
Circuit
Low End (optional
Using circuit
Using Zone
T
1 Inc/Mag
2
3
4 Non-
5 Elec.
Unassigne
_
LUTRO
12345
R
S
elect
C
ircuit
S
elect
V
alue
S
elect
V
alue
D
isplayed
N
N
H
H
To Next Page
Loading...
