10
S
ELECT
V
ALUE
D
ISPLAYED
Load Type
Circuit
Control and Zone Assigned
Using circuit schedule
Value
3
4
5
1 Inc/Mag LV
2 Fluorescent
3 Neon/CC
S
ELECT
V
ALUE
V
IEW
V
ALUE
4 Non-dim
5 Elec. LV
– Unassigned
S
ELECT
C
IRCUIT
Link Status
Using Zone Capture
Low End Trim (optional)
High End Trim (optional)
Circuit Level
TM
®
Power OK (Pins 1,2)
Data OK (Pins 3,4)
2
1
To change Load Types:
A. Press and hold buttons 1 and 5 until
LED lights.
B. Press button 5 repeatedly until Load Type lights.
C. Tap button 2 so that ‘AC’ (All Circuits) appears in
the Circuit display.
D. Press button 3 repeatedly (press button once per
second since updating is slower in all circuits) until
‘4’ appears in the Value display.
E. Press and hold buttons 1 and 5 until
VIEW VALUE LED lights.
Notes:
• Most applications will use Load Type 4. Use Load
Type 6 for circuits controlling screens.
• The Circuit Selector Display will go out automatically
after 20 minutes of the last button press.
• Mark all changes to the Circuit Selector’s Values on
the Circuit Directory for future reference.
S
ELECT
V
ALUE
D
ISPLAYED
Load Type
Circuit
Control and Zone Assigned
Using circuit schedule
Value
3
4
5
1 Inc/Mag LV
2 Fluorescent
3 Neon/CC
S
ELECT
V
ALUE
V
IEW
V
ALUE
4 Non-dim
5 Elec. LV
– Unassigned
S
ELECT
C
IRCUIT
Link Status
Using Zone Capture
Low End Trim (optional)
High End Trim (optional)
Circuit Level
TM
®
Power OK (Pins 1,2)
Data OK (Pins 3,4)
2
1
STEP 9: Assign Load Types
Assigning Load Types is done using the Circuit
Selector located in each XP Series panel.
Press button 5 repeatedly until Load Type lights.
Use buttons 1 and 2 to view present load type of each
circuit. Note that ‘ - ’ in the Value display means a
Load Type is not assigned to the circuit.
If load types are already assigned, compare them to
the Circuit Directory (if provided).
If there are no changes to be made, skip to Step 10.
Circuit Selector
Assign Load Types
A,F
SELECT VALUE
Step by Step instructions for GRAFIK Eye Switching Panel
44
44
4
For More Information...
Circuit Selector Functions.................23
Circuit Directory.................................26
?
To Next Page
Loading...
