13
For More Information...
Circuit Directory.................................26
Control Directory...............................27
?
Check System
STEP 12: Check System
Until zones are assigned in Step 13, all circuits will be
controlled by the first zone of the GRX-4000 Series
Control Unit addressed to ‘A1’. Locate zone 1 of this
‘A1’ control (referred to as A1 1 in the Circuit Selector)
and use it to check that all circuits turn ON and OFF
as expected.
(This address was set in Step 10.)
Note:
If the system has already been Set Up, scenes will
work and A1 1 will not control all circuits.
SM
LUTRON
FADE OVERRIDE
ZONE
MASTER
ZONE 6ZONE 5ZONE 4ZONE 3ZONE 2ZONE 1
First zone of GRX-4000 Series
Control Unit addressed ‘A1’
Step by Step instructions for GRAFIK Eye Switching Panel
To assure proper Set Up, you must have
one or more of the following:
• Factory Customized Set Up.
• Knowledge of how the system is
to operate.
• Plans and specifications from owner’s
representative on how the system is to
be set-up.
• Owner or owner’s representative
STOP!
Possible questions:
•
What should each scene be used for?
Examples include - Day lighting, Night lighting,
Meeting, Accenting, etc...
•
Which circuits should be on in each scene?
To Next Page
Loading...
