14
S
ELECT
V
ALUE
D
ISPLAYED
Load Type
Circuit
Control and Zone Assigned
Using circuit schedule
Value
3
4
5
1 Inc/Mag LV
2 Fluorescent
3 Neon/CC
S
ELECT
V
ALUE
V
IEW
V
ALUE
4 Non-dim
5 Elec. LV
– Unassigned
S
ELECT
C
IRCUIT
Link Status
Using Zone Capture
Low End Trim (optional)
High End Trim (optional)
Circuit Level
TM
®
Power OK (Pins 1,2)
Data OK (Pins 3,4)
2
1
S
ELECT
V
ALUE
D
ISPLAYED
Load Type
Circuit
Control and Zone Assigned
Using circuit schedule
Value
3
4
5
1 Inc/Mag LV
2 Fluorescent
3 Neon/CC
S
ELECT
V
ALUE
V
IEW
V
ALUE
4 Non-dim
5 Elec. LV
– Unassigned
S
ELECT
C
IRCUIT
Link Status
Using Zone Capture
Low End Trim (optional)
High End Trim (optional)
Circuit Level
TM
®
Power OK (Pins 1,2)
Data OK (Pins 3,4)
2
1
Assign Zones
STEP 13: Assign Zones
A. Press and hold buttons 1 and 5 until
lights.
B. Press button 5 repeatedly until
Using Circuit Schedule lights.
C. Use buttons 3 and 4 to assign control (factory set
to A1) and zone (factory set to 1) for each circuit.
Whichever item is blinking can be changed. See
the Control Schedule for control locations. If zones
are already assigned, skip to Step 15.
Example - If the control desired is addressed to
‘A2’ and the zone desired is the 3rd from the left,
use buttons 3 and 4 to get ‘A23’ as a value for the
appropriate circuit.
D. Use buttons 1 and 2 to change to the next circuit
and then repeat Step C. Do this for all affected
circuits. Record each circuit’s control and zone on
the Circuit Directory.
E. Press and hold buttons 1 and 5 until
VIEW VALUE lights. The Circuit Selector’s
display will go out automatically after 20 minutes
of the last button push.
Notes:
• More than one circuit can be assigned to the
same zone.
•
Zone Capture TM
is an alternate method for
assigning zones. It is described in the Circuit
Selector Functions Reference Sheet.
A,E
SELECT VALUE
Step by Step instructions for GRAFIK Eye Switching Panel
For More Information...
Circuit Selector Functions.................23
Circuit Directory.................................26
Control Directory...............................27
?
To Next Page
Loading...
