Lynx L27-2 User Manual

22

W
ait a few seconds and
r
elite a burner.
Bulk
LP
C
ylinder
U
sers
Bulk
LP
cylinder lines must
be properly regulated.
E
nsure that you are using
a 4/11 appliance regulator
supplied by
a 4/11 appliance regulator
supplied by
a 4/11 appliance regulator
L
ynx and
a 4/11 appliance regulator
ynx and
a 4/11 appliance regulator
Lynx and L
converted to
supplied by
converted to
supplied by
LP
gas.
A
lso
ensure that you do not have
more than one regulator in
line.
N
ATURAL
G
AS UN
I
TS:
S
UPPLY
L
INE
E
nsure that the supply line is
at least 3/4” inside diameter
nsure that the supply line is
at least 3/4” inside diameter
nsure that the supply line is
or 1” outside diameter.
C
HEC
K
LINE P
K LINE PK
R
ESSU
R
E
N
atural gas inlet pressure
should be at least 7”
atural gas inlet pressure
should be at least 7”
atural gas inlet pressure
W
.
C
atural gas inlet pressure
C
atural gas inlet pressure
.
and manifold pressure not
less that 4”
and manifold pressure not
less that 4”
and manifold pressure not
W
.
C
and manifold pressure not
C
and manifold pressure not
. under full
and manifold pressure not
. under full
and manifold pressure not
load (with all burners on.)
C
HEC
K
B
U
R
NE
R
S FO
R
B
LOC
K
AGES
KAGESK
C
HEC
K
FLAME CHA
K FLAME CHAK
R
-
ACTE
R
ISTICS.
(
S
ee
INDE
X:
“
F
lame,
C
orrect
S
ize” )
C
LEAN O
R
AD
J
UST AI
R
SHUTTE
R
(
S
ee
INDE
X: “
A
ir
S
hutter
A
djustment.”
L
O
W
OR
I
NSUFF
I
C
I
ENT
H
EAT
N
O PA
R
T OF THE G
R
ILL
SHOULD E
V
E
R
B
E LINED
WITH ALUMINUM FOIL.
D
oing so will interfere with
airow and can cause a low
oing so will interfere with
airow and can cause a low
oing so will interfere with
heat condition.
E
nsure that you’ve preheated
the main burners for at
nsure that you’ve preheated
the main burners for at
nsure that you’ve preheated
least 10 to 15 minutes with
the hood closed and the
P
ro
S
ear™ burner for 3
minutes.
P
roper leveling during instal-
lation is critical.
roper leveling during instal-
lation is critical.
roper leveling during instal-
A
grill that is
roper leveling during instal-
grill that is
roper leveling during instal-
out of level will cause erratic
grill that is
out of level will cause erratic
grill that is
burner combustion and inef-
cient, uneven heating. A
carpenter’s spirit level should
be used to level the grill both
carpenter’s spirit level should
be used to level the grill both
carpenter’s spirit level should
front-to-back and side-to-side.
be used to level the grill both
front-to-back and side-to-side.
be used to level the grill both
If the low heat problem
persists:
C
HEC
K
THE GAS SUPPLY
K THE GAS SUPPLY K
LINE SI
Z
ING
R
E
Q
UI
R
E-
MENTS.
C
HEC
K
THE GAS SUPPLY
K THE GAS SUPPLY K
LINE FO
R
K
IN
K
S O
R
DAMAGE.
R
EPLACE
any damaged
supply lines.
CHEC
K
THE
R
EGULATO
R
M
ake sure that the regulator
& hose assembly is the one
designed for and supplied
& hose assembly is the one
designed for and supplied
& hose assembly is the one
A yellow ame on the main
burners indicates a lack of air.
A yellow ame on the main
burners indicates a lack of air.
A yellow ame on the main
But, if the air around the grill
is dusty or if heavy grease is
But, if the air around the grill
is dusty or if heavy grease is
But, if the air around the grill
present, some orange tips on
the burner ame are normal.
present, some orange tips on
the burner ame are normal.
present, some orange tips on
AD
J
UST
THE
AI
R
SHUTTE
R
To adjust for insufcient air,
adjust the air shutter.
(
S
ee
INDE
X: “
A
ir
S
adjust the air shutter.
S
adjust the air shutter.
hutter
adjust the air shutter.
hutter
adjust the air shutter.
A
djustment” for
adjust the air shutter.
djustment” for
adjust the air shutter.
further details.)
with your
L
ynx grill and that
Lynx grill and that L
it is corr
ectly set up for the
with your
ectly set up for the
with your
ynx grill and that
ectly set up for the
ynx grill and that
type of fuel you are using.
ectly set up for the
type of fuel you are using.
ectly set up for the
(
S
ee
INDE
X: “Regulator
C
onver-
sion” for further details.)
T
he hose and regulator
provided by
L
ynx must be
Lynx must be L
used if your grill is set-up for
provided by
used if your grill is set-up for
provided by
ynx must be
used if your grill is set-up for
ynx must be
an
LP
G
used if your grill is set-up for
G
used if your grill is set-up for
as
C
used if your grill is set-up for
C
used if your grill is set-up for
ylinder.
used if your grill is set-up for
ylinder.
used if your grill is set-up for
C
heck that there is no
physical pressure being
applied to the regulator
physical pressure being
applied to the regulator
physical pressure being
attached to the back of the
applied to the regulator
attached to the back of the
applied to the regulator
grill.
T
he regulator contains
a exible diaphragm and
grill.
a exible diaphragm and
grill.
he regulator contains
a exible diaphragm and
he regulator contains
should not be allowed to
a exible diaphragm and
should not be allowed to
a exible diaphragm and
touch the grill body or its
surroundings.
CHEC
K
FO
R
O
B
ST
R
UC
-
TIONS
E
nsure that the burners and
drip tray are clean and free
from obstructions.
drip tray are clean and free
from obstructions.
drip tray are clean and free
LP
(
P
ROPANE) UN
I
TS:
I
S THE CYLINDE
R
ALMOST EMPTY?
A
lmost-empty cylinders may
not have sufcient pressure
lmost-empty cylinders may
not have sufcient pressure
lmost-empty cylinders may
to run the burners at high
not have sufcient pressure
to run the burners at high
not have sufcient pressure
heat.
HA
V
HAVHA
E THE LINE
P
R
ESSU
R
E CHEC
K
ED
B
Y
A
Q
UALIFIED TECHNI-
CIAN
(
S
ee
INDE
X: “
G
as
Requir
ements” for further
details.)
F
LOW
L
IMITING
D
E
V
ICE
I
mproper lighting proce-
dures may have activated
mproper lighting proce-
dures may have activated
mproper lighting proce-
the LP cylinder’s ow control
dures may have activated
the LP cylinder’s ow control
dures may have activated
device, reducing the heat
output.
To reset the ow control:

S
hut off all burner
controls and close the
LP
cylinder valve.

W
ait 30 seconds and,
very slowly
, reopen the
very slowly, reopen the very slowly
cylinder valve.
, reopen the
cylinder valve.
, reopen the
W
I
ND H
I
TT
I
NG
G
R
I
LL
W
ind hitting the grill while in
use, especially winds blowing
into or acr
oss the hood gap
use, especially winds blowing
oss the hood gap
use, especially winds blowing
from behind, can cause poor
oss the hood gap
from behind, can cause poor
oss the hood gap
performance and in some
from behind, can cause poor
performance and in some
from behind, can cause poor
cases can cause the control
performance and in some
cases can cause the control
performance and in some
panel to get dangerously hot.
S
teady or
gusty winds
can prevent
the normal
can prevent
the normal
can prevent
exhaust of hot
gases.
L
ocate
your grill
away
ing winds and avoid grilling in
windy conditions.
panel to get dangerously hot.
exhaust of hot
ocate
away
from prevail-
ing winds and avoid grilling in
from prevail-
ing winds and avoid grilling in
from prevail-
YELLO
W
FLAMES

Lynx L27-2 Specifications

General

Brand	Lynx
Model	L27-2
Category	Grill
Language	English