Lynx L27-2 User Manual

37
P
ull off the control knob.
W
hile holding the valve
shaft with pliers, insert a
hile holding the valve
shaft with pliers, insert a
hile holding the valve
thin at-blade screwdriver
shaft with pliers, insert a
thin at-blade screwdriver
shaft with pliers, insert a
into the shaft and, while
watching the ame, adjust
it to a minimum stable
setting.
B
RASS
B
URNER
FLAME/
AI
R
S
H
UTTER
A
DJUSTMENT
T
he amount of air that enters
a bur
ner is controlled by the
air shutter
.
E
ach grill burner is tested and
adjusted at the factory prior to
ach grill burner is tested and
adjusted at the factory prior to
ach grill burner is tested and
shipment. However, uctua
adjusted at the factory prior to
shipment. However, uctua
adjusted at the factory prior to
-
tions in gas pressure, gas con-
version and even in the quality
tions in gas pressure, gas con-
version and even in the quality
tions in gas pressure, gas con-
of the gas itself may make it
version and even in the quality
of the gas itself may make it
version and even in the quality
necessary to adjust the burner.
The ames of the main brass
burners should be visually
checked
stable with slight yellow tips.
T
he bright-blue core should
stable with slight yellow tips.
he bright-blue core should
stable with slight yellow tips.
be about 3/8 inch high with a
total ame height of about 1
be about 3/8 inch high with a
total ame height of about 1
be about 3/8 inch high with a
setting.
U
se a small screwdriver for low-set-
ting bur
ting bur
ner adjustment.
ner adjustment.
checked
F
lames should be blue and
stable with slight yellow tips.
1/2 inches.
The ames should burn
quietly. (no “torch” sounds)
and they should not “lift” up
quietly. (no “torch” sounds)
and they should not “lift” up
quietly. (no “torch” sounds)
from the burner.
and they should not “lift” up
from the burner.
and they should not “lift” up
If your ames do not match
those indicated in the photo,
ensure that the air shutter and
ensure that the air shutter and
those indicated in the photo,
ensure that the air shutter and
those indicated in the photo,
burner ports are free and clear
burner ports are free and clear
of dirt, debris, or spider webs.
of dirt, debris, or spider webs.
burner ports are free and clear
of dirt, debris, or spider webs.
burner ports are free and clear
burner ports are free and clear
of dirt, debris, or spider webs.
burner ports are free and clear
I
f clear, then adjust the air
f clear, then adjust the air
of dirt, debris, or spider webs.
f clear, then adjust the air
of dirt, debris, or spider webs.
of dirt, debris, or spider webs.
f clear, then adjust the air
of dirt, debris, or spider webs.
shutter.
shutter.
I
t is locked in place by a screw
t is locked in place by a screw
which must be loosened
which must be loosened
t is locked in place by a screw
which must be loosened
t is locked in place by a screw
t is locked in place by a screw
which must be loosened
t is locked in place by a screw
before adjusting.
before adjusting.
O
nce
adjusted retighten the screw.
adjusted retighten the screw.
T
T
o
To T
A
djust:
Remove the racks and
briquette trays.
L
ift out the burner, loosen
the set screw and then put
the burner back in place
the set screw and then put
the burner back in place
the set screw and then put
and light it.
the burner back in place
and light it.
the burner back in place
If the ame is excessively
yellow
, indicating insuf-
If the ame is excessively
, indicating insuf-
If the ame is excessively
cient air, CAREFULLY turn
yellow
cient air, CAREFULLY turn
yellow
, indicating insuf-
cient air, CAREFULLY turn
, indicating insuf-
the air shutter counter-
clockwise to allow more air
to the burner.
If the ame is noisy (sounds
like a tor
ch) and tends to
danger!
Be extremely careful
around hot
B
urners
and other grill parts.
If the ame is excessively
lift away from the burner,
indicating too much
air, turn the air shutter
clockwise.
A
fter the burner cools
down, remove it, tighten
the air shutter set screw
and reinstall the burner,
briquette trays and grill
racks.
briquette trays and grill
racks.
briquette trays and grill
ONE LAST T
HI
NG:
F
inally, before leaving, check
all the bur
ners for proper
inally, before leaving, check
ners for proper
inally, before leaving, check
operation.
M
ake sure the
ners for proper
ake sure the
ners for proper
control knobs turn freely and
operation.
control knobs turn freely and
operation.
completely through their full
control knobs turn freely and
completely through their full
control knobs turn freely and
range.
I
MPORTANT
:
MPORTANT:MPORTANT
M
ake sure the owner knows
where the main gas supply
shut off valve is located.
where the main gas supply
shut off valve is located.
where the main gas supply
F
inally, for safety and for
proper use & care, you
must leave this manual with
the owner.
M
ake sure you
advise them to keep it for
ake sure you
advise them to keep it for
ake sure you
future reference.
F
or technical assistance call:
L
ynx
Lynx L
T
echnical
Technical T
S
upport
888-289-5969

Lynx L27-2 Specifications

General

Brand	Lynx
Model	L27-2
Category	Grill
Language	English