4.7 Repeat Key
Lynx can repeat your last cutting job at the same position by pressing the REPEAT key without setting a new
origin. If you’re using a thicker media, it is better to use this function to avoid damaging your blade.
Procedures:
1. After cutting fi nishes, use the ARROW keys to move the tool carriage. Move to your desired position
for repeating the cutting job, and then press the ORIGIN SET key. The ORIGIN SET LED lights, and new
origin point is set.
2. Press the REPEAT key to start re-cutting job, and the REPEAT LED lights.
4.8 DATA CLEAR Key
The purpose of the DATA CLEAR key is to clear the data in the buffer memory. The DATA CLEAR key only
works when cutter is paused or offl ine. When use this function, the DATA CLEAR LED will light.
4.9 Origin Setting
Use the ORIGIN SET key to set a new origin at any position in the cutting area from where the tool carriage
starts to work. Please note that a new origin setting must be made under the off-line condition.
Procedures:
1. After loading the media and lowering down the level, use ARROW keys to move the carriage to the
desired location for a new origin.
2. Press ORIGIN SET key and the origin point is set. The ORIGIN SET LED lights.
4. Basic Operation 4-9
To Next Page
Loading...
Need help?
General
