EasyManua.ls Logo

Lynx Yeti 550 - Heated Grip & Throttle Controls

Lynx Yeti 550
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. Full
2. Empty
WARNING
Always stop the engine before re-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventila t ed
area. D o not smoke or allow open
flames or sparks in the vicinity.
Open ca p slowly. If a differe n-
tial pressure c o ndition is not iced
(whistling sound heard when loos-
ening fuel tank cap) have vehicle
inspected and/or repaired before
further operation. Do not over-
fill or top off the fuel tank before
placing the vehicle in a warm area.
As temperature increases, fuel
expands and might overflow. Al-
ways wipe off any fuel spillage
from the vehicle. Periodically ver-
ify fuel s ystem .
NOTE: Do not sit or lean o n seat when
fuel tank cap is not properly installed.
20)Heatinggripswitch
It is a three– position switc h. Sele ct
the desired position to keep your
hands at a comfortable temperature.
YETI MODELS
1. Heated grip switch
2. Heated throttle lever swit ch
3. Hot
4. Warm
5. OFF
21) Heated throttle lever
switch
Three-position switch. Select the de-
siredpositiontokeepyourrightthumb
at a com forta ble temperature. See il-
lustration.
Rear passengers heated
grip switches
Three-position switch. Select the de-
sired position to keep rear passenger’s
hands at comfortable temperature.
22) Hood latches
Stretch and unhook the latches to un-
lock the hood from its anchors. Lift
hood gently until stopped by retaining
device. Close hood slowly then hook
up latches.
23) Power outlet
A 12-volt electric appliance may be
connected to the jack connector. Elec-
tric curre n t is supplie d when ever en -
gine is running. See FUSES for elec-
tric power outlet fuse location.
_____________________
33

Table of Contents

Related product manuals