TROUBLESHOOTING
Monitoring beeper coded signals
CODED SIGNAL POSSIBLE CAUSE REMEDY
2 short be eps (when
engine is started).
DESS/RER pi lot lamp
also blinks.
Confirms that proper tether
cord cap is installed.
Normal condition.
1 short beep every 1,5
seconds (when engine is
started). DESS/RER pilot
lamp also blinks. Engine
cannot reach engagement
speed. Vehicle cannot be
driven.
Bad DESS system
connection. Defective
tether cord cap. Dirt or
snow in tether cord cap.
Defective DESS post.
Reinstall tether cord cap
correctly over po st. Use
another programme d
tether cord cap. Clean
tether cord cap. Contact
an authorized Lynx dealer.
1 long beep pe r second.
SDI 0,5 sec beep every 0,5
sec
Reverse is selected Vehicle can be driven in
reverse
3 short beeps per second.
DESS/RER pil ot lamp also
blinks. Engine cannot
reach pulley engageme nt.
Vehicle cannot be driven.
Wrong tether cord cap is
installed
Install proper tether cord
cap.
3 short beeps per second.
Engine overheating pilot
lamp also blinks. SD I 80ms
beep every 260ms temp
lamp also blinks.
Engine is overheating
Stop engine immediately
and allow to cool. If tro ubl e
persists, see an authorized
Lynx dealer.
3 short beeps per second.
Oil pilot lamp also li ghts up.
Low oil pressure on 4 –tec
models.
Stop engine immediately
and allow to cool. If tro ubl e
persists, see an authorized
Lynx dealer.
3 short beeps per second.
Battery pilot lamp also
lights up. SDI 80ms beep
every 260ms batt lamp
also blinks.
Low battery voltage
Check battery and charging
system, see an authorized
Lynx dealer.
4 short beeps every 2
minutes. Oil pilot lamp also
lights up.
Low oil level on 2 –tec
models.
Check oil level and add oil
as soon as possible.
4 short beeps every 2
minutes. Engine pilot
lamp also lights every 3
seconds.
Too high battery voltage.
DESS system has detected
a shorted key installed on
DESS post.
Use another pro grammed
tether cord cap.
72
______________________
To Next Page
