EasyManua.ls Logo

Lynx Yeti 550 - VEHICLE WARM-UP

Lynx Yeti 550
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VEHICLE WARM-UP
Before every ride, vehicle has to be
warmed up as follo ws:
Snowmobile must be securely sup-
ported by the rear bumper using a
wide-base snow mobile mechanical
stand. Track must be 100 mm off the
ground.
Start engine and allow it to warm up
two or three minutes at idle speed.
Release b arking brake.
WARNING
Make sure wide-base snowmobile
mechanical stand is stable. Stay
clear of the front of vehicle and the
track. Do not use too much throttle
during warm-up or when track is
free-hanging.
Apply throttle until drive pulley en-
gages. Let track ro tate at low speed
for several turns. The lower the vehi-
cle temperature is the longer vehicle
warm-up should be.
Shut-off the engine and remove the
wide base snowmobile mechanical
stand.
Skis may be frozen on the ground.
Grab both skis one at a time by their
loops a nd lift t heir front end slightly off
the ground.
After restarting engine, the vehicle can
be driven at low speed for the first 2 or
3 m inutes of riding. After that, it may
be driven up to the legal speed limit as
per normal safety practices.
50
______________________

Table of Contents

Related product manuals