Lynx Yeti 550 - ENGINE SYSTEM; Engine Oil & Filter Change

ENGINE SYSTEM
Engine Oil Level
4-Stroke Engine
CAUTION: Check level frequently
and refill if necessary. Do not over-
fill. Operating the engine with an
improper level may severely dam -
age engine. Wipe off any spillage.
RH SIDE OF ENGINE COMPARTMENT
1. Dipstick
With vehicle on a level surface and
engine cold, not running, check the oil
level as follows:
1. Remove dipstick and wipe clean.
2. Rein stall dips tic k.
3. Remove and check oil level. It
should be near or equal to the up-
per mark.
1. Full
2. Add
3. O perating range
To add oil, remove dipstick. Place a
funnel into the dipstick tube to avoid
spillage .
Add a sm all amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark. Do not overfill.
Properly reinstall dip stick .
Engine Oil/Oil Filter
Change
Yeti v-800
Snowmobile has to stand on a level
surface.
1. Let engine run until it reaches nor-
mal running temperature.
2. Shut down the engine.
3. Remove dipstick.
4. Open drain plug (1) and dra in oil
into the oil waste can.
_____________________
69