CAUTION: Drai n plug can‘t b e used
on Yeti-Pro 800 model, use applica-
ble pump to change oil trough dip-
stick pipe.
WARNING
Do not touch hot oil by hand !
CAUTION: Dispose u sed oil and oil
filter by following your local regula-
tions.
5. Remove oil filter by op ening the
filter cover (1) and remove filter
cartridge.
6. Replace new oil filter cartridge.
7. Fasten oil filter cover.
8. Fasten drain plug.
9. Fill up recommended oil through
dipstick pipe. (See quantity on
TECHNICAL SPECIFICATION
SECTION for specific model).
10. C heck oil level by dipstick. Add
oil if necessary to reach upper oil
level mark.
11. Install dip stick carefully.
12. Run engine 30 seconds, shut off
engine. Let engine be s hut off 30
seconds and check oil level. Add
oil if necessary to reach upper oil
level mark.
13. Run engine for a while and check
that no oil leakage appear.
70
______________________
To Next Page
Loading...
