Airfiltercleaning
While riding in deep powder snow, pe-
riodically stop then shake the snow
from th e filter. Check that air silencer
is clean and dry and properly reinstall
the filter.
Leaving the snowmobile uncovered
during a snowfall or riding in deep
powder snow may block air filter and
choke the engine. O pen the hood,
remove the a ir filte r ou t o f air sile n cer,
shake the snow from filter and prop-
erly rein stall the filter.
SECONDARY FILTER INSTALLED ON
AIR SILENCER
1. Secondary air filter
REMOVALOFFILTERFROMITSGRILL
Check that the air silencer is clean and
dry and properly reinstall the filter.
CAUTION: Snowmobile have been
calibrated with the filter installed.
Operating the snowmobile without
it may cause engine damage.
Bulb replacement
Always check light operation after bulb
replacem en t.
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
Some models: If headlamp bulb is
burnt: Remove headlight moulding
and windshield, unplug the connector
from the bulb, remove the protector
cap and bulb retainer clips. Install
new headlamp bulb.
Some models: If the headlamp bulb
is burnt: Remove winds hie ld and
headlamp moulding, unplug connec-
tor from h eadlamp, remove protector
cap and turn bulb off, install new head-
lamp bulb.
Instruments
Bulb sock e t is alw ays b ehind the in-
strument under a b lack rubber boot.
Pull rubber boot and pull bulb out of
socket.
66
______________________
To Next Page
