EasyManua.ls Logo

Lynx Yeti 550 - Performance Problems

Lynx Yeti 550
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGINE LACKS ACCELERATION OR POWER (cont’d)
6. Engine is overheating.
– On liquid cooled engines: Check coolant level, pressure cap, thermostat
and for air locks in cooling system. On fan cooled engines: Check fan belt
and its tension; clean cooling fins of engine; if overheating persists , contact
an autho r ized Lynx dealer.
– V-800: Observe the fan function. Check fuse F10.
ENGINE BACKFIRES
1. Faulty spark plug.
– See item ”Engine turns over but fails to start”.
2. Engine is running too hot.
– See item ”Engine lacks acceleration or power”.
3. Ignition timing is incorrect or there is an ignition system failure.
– Contact an authorized Lynx dealer.
ENGINE MISFIRES
1. Fouled/defective/worn spark plug.
– Clean/verify spark plug gap and identification number. Replace as required.
2. Too much oil supplied in engine.
– Improper oil pump adjustment, refer to an authorized Lynx dealer. Too rich
fuel/oil mixture ( on ly during bre ak-in period). Drain fue l tank and refill with
appropriate mixture ratio.
3. Water in fuel.
– Drain fuel system and refill with fresh fuel. Replace fuel filter if needed.
SNOWMOBILE CANNOT REACH FULL SPEED
1. Drive belt.
– Check item ”Engine lacks acceleration or power”.
2. Incorrect track adjustment.
– See MAINTENANCE or an authorized Lynx dealer for proper alignment and
tension adjustments.
3. Pulleys misaligned.
– Contact an authorized Lynx dealer.
4. Engine.
– See item ”Engine lacks acceleration or power”.
_____________________
75

Table of Contents