Lynx Yeti 550 - Page 92

10-HOUR OR 500 KM INITIAL INSPECTION
(1)
WEEKLY OR EVERY 250 KM
(2)
MONTHLY OR EVERY 1000 KM
(3)
ONCEAYEAROREVERY3000KM
(1)
EVERY 2 YEARS OR 6000 KM
(1) (4)
STORAGE
(1)
A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
T: PROCEED WITH TASK
PRES EASON
(1)
PART/TASK
ELECTRICAL SYSTEM
EMS fault codes
(5)
II DIAGNOSTIC PROCEDURE
Spark plugs
(7)
IR SPARK PLUG
Battery
(8)
II II BATTERY
Headlamp beam aiming I I
LIGHTS, INSTRUMENTS AND
ACCESSORIES
Wiring harnesses, cables and lines I I I ELECTRONIC MANAGEMENT
Operation of lighting system (HI/LO beam,
brake light, etc.) test operation of engine
cut-out switch and tether cut-out switch
II I
IGNITION SYSTEM
DRIVE SYSTEM
Drive belt condition I I I
Drive belt height adjustment EACH BELT REPLACEMENT
DRIVE BELT
Drive and driven pulley I I C I C DRIVE PULLEY AND DRIVEN PU LLEY
Drive pulley screw (torque) I I I DRIVE PULLEY
Driven pulley preload
(11)
III DRIVEN PULLEY
Drive chain ten sion (not for models
equipped with gearbox)
AA A
CHAINCASE
Countershaft (RF V-810) L L L COUNTERSHAFT AND BRAKE
BRAKE SYSTEM
Brake fluid I I R I
Brake hose, pads and disk I I I
BRAKE
TRANSMISSION
Chaincase / Gearbox oil
(9)
I
(9)
I
(9)
(9)
RI GEARBOX OR CHAINCASE
Drive axle end bearing (axle without
brake disc)
(6)
LL L
Drive axle end bearing (axle with brake
disc)
I
DRIVE SYSTEM
90
______________________