mabe Kraken - Page 69

Ingeniería de Servicio
- 69 -
Fault Codes
Fault
Code
(Hex)
Name
Description
Repair Action
16
Adapti
ve
Drain/
Slow
Drain
The total number of
times during machine
life the actual amount
of time the pressure
sensor indicated the
wash water had
drained to empty
exceeded the
calculated time by the
software.
 This fault is set when adaptive drain cycle
occurs to try to remove the rest of water in
tub.
 If the adaptive drain cycle times out. The
control will run a Drain Pump Clearing
algorithm to free the pump impeller of debris.
Then it will finish draining. If drain clearing
algorithm fails look for fault 18.
 If fault 16 is 100 and fault 18 never occurs
there is no problem… If fault 16 and fault 18
equal each other in faults, then look for drain
blockages including house standpipe.
17
Dry
Load
Sense
Timeo
ut
Dry load sense times
out and moves to the
next part of the cycle
selected. This occurs
when the washer is
not reaching the target
speed within a defined
time limit for the load
type selected.
1. Check for water in the bottom of the tube. If
so drain and try cycle again.
2. Check the basket for excessive friction.
Basket should spin freely. If not, find source of
friction and remove it.