MADE IN ITALY
28
electric modular oven
The oven must be installed by a technician authorized by the oven manufacturer.
Carefully comply with all accident-prevention regulations
Check that the premises are in conformity with the safety and stability parameters previously
indicated
The floor must be flat, levelled and heat-resistant
Walls next to the oven must not be inflammable
Remove the packing and check the content integrity.
In case of doubts, contact the supplier.
Packing materials (wooden case; cardboard box; nails, staples, plastic bags, etc.) which are
potential sources of danger and pollution, should not be abandoned but deposited in appropriate
areas.
Empty the oven of all the materials in it.
Check the integrity of its content.
Depending on the method requested during ordering, the oven can be supplied:
• ASSEMBLED
the oven is completely assembled. Only certain components are disassembled and placed
the furnace for transport and storage requirements. To complete the assembly, go directly to the
final stages of this chapter.
• PRE-ASSEMBLED
The oven is delivered only partially assembled. The various blocks that make up the oven are, in
fact, only joined by some screws, so that they can be divided later on and to facilitate handling
during final positioning.
To Next Page
Loading...