MADE IN ITALY
6
electric modular oven
The operator and anyone authorized to work with the machine must carefully and thoroughly read
the general safety and caution principles here below in order to avoid any damages caused by the
improper use of the machine. Failure to comply with safety regulations and/or improper use of the
machine may cause accidents to operators and other persons. It is necessary to comply with the
safety regulations included in this manual and displayed on the machine; to maintain the safety
devices installed in efficient conditions; to operate the machine as recommended and specified by
the manufacturer. It is also recommended that you follow the maintenance plans as specified in
Cautions alone are not sufficient to avoid danger!
All the instructions in this manual refer to both new and reconditioned machines.
Instructions and warnings are not replacing effective safety regulations but integrate them and
urge to their compliance.
CAUTION AND SAFETY PRINCIPLES
It is strictly forbidden to have operators run the furnace who have not learnt safety instructions.
This refers to the furnace operators and also to any other furnace user. Access to the area where
the machine is running is forbidden to persons who are not operating the furnace, and they should
not be allowed to control and adjust it. The operator is not allowed to remove running failures or
alter the type of processing.
Anyone who is preparing for maintenance operations should be well visible in order to signal any
danger that may occur. When searching the cause of any trouble or failure of the machine, or for
any ordinary maintenance intervention, all reasonable precautions should be taken to avoid
damages to surrounding people and objects, i.e. switching off all oven connections (electrical,
water and fuel). At the end of any extraordinary intervention requiring the removal of protections,
barriers or similar, make sure that all is re-installed, reset and positioned, and efficiently working. It
is strictly forbidden to tamper, neutralize, remove, modify or make inefficient any safety devices,
protections or controls of the oven (limit switches, protections, casing panels). All protection and
safety devices should be kept in perfect and efficient working conditions. Caution and danger
plates must be kept in their position maintaining their original features. Remember to tight well all
screws, bolts or fixing nuts of all mechanical parts that have been adjusted.
In case of sudden danger, immediately power off the system by means of the main switch
positioned outside the oven. This operation causes the immediate halting of the machine
Position the oven on a flat, heat-resistant surface and set to support the expected load, and far
from any flammable surface.
To Next Page
Loading...