215505 50 Revision A
$
%$
&
%
'
&
Figure 5.40: Five-Bat Reel – Rubber Paddles
2. If removed, install three RUBBER reel end paddles (A) on the OUTBOARD FACE of the endshield assembly using two
M8 X 1.25 X 20 hex bolts (B) and nuts (C) per paddle.
IMPORTANT:
The arrow points to the front of the machine. Ensure the rubber paddles are oriented as shown. The rubber paddles
on both ends of the reel (the outboard cam and outboard tail ends) should be aligned.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
