MAEVING RM1 - Removing and Installing the Primary Battery

13
QUICK START GUIDE
Removing and installing the
primary battery
If the battery needs to be charged before
your journey, it must be removed from the
motorcycle.
To remove the primary battery, turn
the ignition key to the OFF position. The
instrument panel displays OPEN and a 5
second countdown begins.
During the countdown period, press the
battery storage compartment unlock button,
located on the left-hand side handlebar
switch, once (one long press) to unlock
the battery storage compartment. Pull the
handle outward to open the compartment.
Using the carry handle, carefully remove
the battery from the battery storage
compartment.
To install the primary battery, open the
primary battery storage compartment, and
carefully lift the battery and lower it into
position.
Note: Make sure the ignition key is in
the OFF position before installing the
primary or secondary battery.
For further information, see Removing and
installing the primary battery on page 28.
Make sure the battery terminals locate into
the connector within the primary battery
storage compartment and close the battery
storage compartment.
Also make sure that the battery’s LED charge
indicator is facing the front wheel of the
motorcycle.
A secondary battery can be inserted into
the storage compartment which would
traditionally be the fuel tank.
For further information, see Removing
and installing the secondary battery on
page 31.
40
60
30
20
10
MPH
km/h
0
CHARGE %
80
40
20
50
! ! !