Maeving | RM1 Owner’s Handbook
60
12-VOLT BATTERY
12-volt battery removal and installation
Warning: The electric motorcycle components should only be
serviced by qualified personnel. Specialist tools and personal
protective equipment are required for working on any electric
vehicles. Unqualified personnel can potentially cause serious
personal injury or death.
To remove the 12-volt battery:
1. Make sure the ignition key is in the OFF position.
2. Remove the battery access panel. For further information, see
12-volt battery access panel on page 59.
3. Disconnect the negative (-) and positive (+) battery connectors.
4. Release the retaining strap and remove the 12-volt battery.
Note: The installation procedure is the reverse of removal.
3
4
To Next Page
Loading...