Maeving | RM1 Owner’s Handbook
64
FUSES
Accessing the fuse box
Warning: The electric motorcycle
components should only be serviced
by qualified personnel. Specialist
tools and personal protective
equipment are required for working
on any electric vehicles. Unqualified
personnel can potentially cause
serious personal injury or death.
To access the fuse box:
1. Make sure the ignition key is in the OFF
position.
2. Remove the 12-volt battery. For further
information, see 12-volt battery removal
and installation on page 60.
3. Remove the 5 bolts securing the battery
carrier insert to the electronics housing,
reposition the 12-volt battery wires and
remove the insert. You are now able to
access the fuse box.
Note: When refitting, tighten to 8 Nm.
Fuse identification
The motorcycle uses mini fuses.
Fuse No. Value Description
1 5A
Immobiliser and
accessory GPS tracker
2 5A
Diagnostic tool
connector
3 5A USB-C charger
4 5A Instruments
5 10A Ignition power
6 15A
Storage tank and
battery compartment
actuators
Spare fuses (in fuse box lid): 5A and 15A.
3
To Next Page
Loading...