MAEVING RM1 - Installing the Secondary Battery; Charging the Battery

To Next Page

To Previous Page

Maeving | RM1 Owner’s Handbook

BATTERY

Installing the secondary battery

1. Open the storage compartment. For further information, see

Storage compartment on page 36.

2. Turn the ignition key to the OFF position.

3. Carefully lift the secondary battery and align it with the

secondary battery storage compartment before inserting.

Note: The LED indicator on the secondary battery must be

located to the right, as shown.

4. Carefully lower the battery (1) and push forward into position (2),

making sure that the battery fully engages with the connector.

Charging the battery

Your motorcycle is supplied with a combined battery charger (1) and

a charging base unit (2).

Find a suitable location to charge your battery. This should be:

• Out of direct sunlight;

• Not exposed to water;

• On a ﬁrm and level surface; and

• In an ambient temperature of +10 °C to +35 °C.

Plug the charging base into the battery ﬁrst, then plug the battery

charger into the mains. Make sure that the charging base unit sits ﬂat

and the electrical cables are fully extended and free of knots.

Caution: Only use the ocial charger supplied by Maeving to

charge your battery. Using an incorrect charger may damage

the battery and may result in a ﬁre.

! ! !