Magicfx ECO2JET - Page 14

14 MAGICFX
®
ECO2JET
®
- User and Installation Manual
Menu function Explanation
Lock/Unlock
Controller
Holding the Lock button for more than 5 seconds will “lock” the
display functions. Meaning buttons will not respond. This to avoid
accidental change of parameters via display. To unlock, hold
the Unlock button for more than 5 seconds. In case system is
armed display is locked.
Reset Errors In case there is a locking error present, this button will reset the
appliance. If the fault does not persist, the locking error will not
reappear.
DMX Personality
(STANDARD/
EXTENDED)
Set the DMX personality to standard (enable & start channel) or
extended (enable & start + heater channel)
DMX Start Address
(1-512)
Setting the DMX start address.
DMX Enable
Address (1-512)
Setting the DMX Enable Address.
DMX Footprint This parameter indicates the DMX footprint, in other words the
amount of sequential channels used by the appliance. This does
not include the enable channel.
RDM (On/O) Use this function to turn on/o the RDM functionality.
Test Mode (ON/
OFF)
Enable the Test Mode. The device will start the eect aer 3
seconds. The eect will run 1 - 8 seconds set in the run timer. The
device then pauses for 1-60 seconds set in pause timer.
Run Timer (1-8 s) Set the duration of the eect in Test Mode.
Pause Timer (1-60
s)
Set the duration of the pause between eects in in Test Mode.
Hold to prime Hold the prime button to manually prime the device.
Heat-up Power
Mode (ECO/FULL)
Use this function to toggle between dierent heat-up power
modes: ECO (1500 W), FULL (3500 W)
Heater (ON/OFF) Enables or disables the heater. This setting can also be set using
the DMX heater channel when in EXTENDED mode, or by RDM.
Display Flip Change the display orientation from normal to upside down. In
auto mode the machine automatically adjusts the display
orientation to the position.
Display Dimmer
(On/O)
Turn display dimmer on or o. If turned on, the display is dimmed
automatically 30 seconds aer the last button push.
Factory Defaults
(Yes/No)
Restores the appliance factory default settings.
Menu functions