MAGICFX
®
ECO2JET
®
- User and Installation Manual 27
6
CAUTION
Take the recoil of the ECO2JET
®
into account. Make sure
the construction is prepared for the counter force of
firing the eect.
3. Secure the ECO2JET
®
onto the truss with use of a safety wire on the bottom of
the ECO2JET
®
. Make sure the safety wire is as short as possible. If needed, wind
the cable around the truss to pull it tight.
6
CAUTION
The safety steel and the emergency link need to have
a minimal workload of 40 kg.
4. By default, the machine is programmed to autoflip the display. However, to
preserve a particular configuration use “flip mode” in the menu. This will allow
to preserve a desired setting without any automatic adjustments.
5. Make sure that the installation complies with all relevant safety requirements,
such as creating a safety zone and a free output zone, see Section 2.6.
To Next Page
Loading...