[]Auto Channel Scan
Ifyouswitchwires(e.g.,betweenantennaandCATV)orifyoumovethe
unitto adifferentareaaftertheinitialsetting,orifyonrecovertheDTV
channelyoudeleted,youwill needtoperformautochannelscan.
Beforeyoubegin:
Makesureiftheunitisconnectedtoantennaorcable.
1 Press [SET-UP] to display the main menu.
SET-UP
2
3
Use [Cursor AIr] to select"CHANNEL SETUP",
then press [ENTER].
e.g.) digital TV mode
- TV SETUP -
CHANNEL SETUP
V-CHIP SETUP
L_NGUAGE [ENGLISH]
CAPTION [OFF]
DTV SETUP
Use [Cursor AIr] to select your desired preset
type, then press [ENTER].
e.g.) digital TV mode
- CNANNELSETUP -
ADD/DELETE (DTV)
_- AUTO PRESET CH (DW)
AUTO PRESET OH (TV/DTV)
AUTO PRESET CH (CAW)
! OATV takes approx. 50min.
•When aerial antenna is connected, select"AUTO
PRESETCH(TV)","AUTO PRESETCH (DTV)" or"AUTO
PRESETCH(TV/DTV)".
•When connected to CATV,select"AUTO PRESETCH
(CATV)".
•Auto scanning begins.
e.g.) digital TV mode
D25
AUTOPRESET CH(DTV)
II
• When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
• When you selected "AUTO PRESETCH (TV/DTV)", the
lowest memorized analog channel will be displayed
when the scanning and memorizing are completed.
If there is no analog channel, the lowest memorized
digital channel will be displayed.
Note:
•If you connect the cable systemdirectly, contact the CATV
installer.
•If you press[STANDBY-ONO] or [SET-UP]during "AUTO
PRESETCH';the setting will be canceled.
• When no channel can bereceived by "AUTOPRESETCH';
"NO TVSIGNALS"isdisplayed on the TVscreen.
• Channel setting will be saved even if the power fails.
•If you have Spanish or French menus and need English,
press[SET-UP].Use[CursorA/V] to select "IDIOMA" or
"LANGAGE'[Press[ENTER] to select "ENGLISH"
Press[SET-UP] to remove the main menu.
• With regard only to the digital channel, even after the scan-
ning iscomplete if you unplug the ACpower cord before
turning off the unit by pressing [STANDBY-ONO ], the
channel setting may be lost.
[] Language Selection
YoucanchooseEnglish,Spanish,orFrenchasyour on-screenlanguage.
1 Press [SET-UP] to display the main menu.
SET-UP
2 Use [Cursor AIr] to select"LANGUAGE",
then press [ENTER] repeatedly to change the setting.
e.g.) digital TV mode
- TV SETUP -
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
DTMSETUP
NGLISH]
[ISPANOL]
RAN_AIS]
3 Press [SET-UP] to exit.
SET-UP
EN
To Next Page
Loading...
Need help?
General
