What to do if LEVEL reading is correct but LOOP is stuck at 4 mA on Magnetrol Transmitter?
If the LEVEL reading on the Display is correct, but the LOOP is stuck on 4 mA, the basic configuration data might be questionable. Set the POLL ADR to 0 if you are not using HART multi-drop.
Why are LEVEL readings on Magnetrol Measuring Instruments consistently inaccurate?
If LEVEL readings are consistently high or low by a fixed amount, the configuration data might not accurately match the probe length or tank height. Ensure the proper Probe Model, Level Offset, or probe length is configured. You can also adjust the trim level value by the amount of noted inaccuracy.
What to do if the LEVEL reading is stuck at full scale on Magnetrol eclipse 705?
If the LEVEL reading on the display is stuck at full scale, the software might believe the probe is flooded. Check the actual level. If the probe isn't flooded, inspect for buildup or obstructions near the top of the probe. You may also select a higher dielectric range, check for condensation in the probe connection, or add Blocking Distance.
How to troubleshoot inaccurate LEVEL and % OUTPUT values on Magnetrol Measuring Instruments?
If the LEVEL and % OUTPUT values are inaccurate, the basic configuration data might be questionable, or the interface level may have significant emulsion. You can reconfigure the Probe Model, Probe Mount, Probe Length, or Level Offset. Also, examine the process to reduce or eliminate the emulsion layer.
What does it mean when EOP is less than probe length on Magnetrol Transmitter?
If the EOP (End of Probe) is less than the Probe Length, the End of Probe signal from a dry probe is out of range. Ensure the probe length is entered correctly. Also, set the transmitter to a lower dielectric range and ensure proper blocking distance.
What does EOP High mean on Magnetrol Transmitter?
If you see 'EOP High', it means the End of Probe signal is out of range. Ensure the probe length is entered correctly.
How to resolve 'Lo Temperature' warning on Magnetrol eclipse 705 Measuring Instruments?
If the present temperature in the electronics compartment is below -40°F (-40°C), the transmitter may need to be moved to ensure the ambient temperature is within specification, or change to a remote transmitter.
How to fix inaccurate LEVEL, % OUTPUT, and LOOP values on Magnetrol Transmitter?
If the LEVEL, % OUTPUT, and LOOP values are all inaccurate, the basic configuration data might be questionable. Try reconfiguring the Probe Model, Probe Mount, Probe Length, or Level Offset. Also, ensure the Level is accurate and verify the 4 mA and 20 mA Loop values.
How to troubleshoot 'EOP High' error on Magnetrol Measuring Instruments?
If the End of Probe signal is out of range, ensure the Probe Length is entered correctly.
Why is the LEVEL value reading high when it should be zero on Magnetrol eclipse 705 Measuring Instruments?
If the LEVEL value is reading high when it should be zero, the transmitter might be loose or disconnected from the probe. Ensure the transmitter is securely connected to the probe.
General| Brand | Magnetrol |
|---|---|
| Model | eclipse 705 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
