3.2 INSPECTION
Before and after disassembly,inspect each part for points mentioned below,and replace if necessary.
0.5 mm
(0.020 in)
0 mmThrust play of fixed gears
-51.17
(2.015in)
Assembled width of synchromesh
assembly
0.5mm
(0.020 in)
0.1-0.2mm(0.004-0.008in)Backlash of each gear(measured in meshed condition)
0.5 mm
(0.020 in)
Wear in each shifter
9.5Kgf
(20.9 lbs)
13.0-18.8Kgf
(28.7-41.4lbs)
Synchro-hub thrust for shifting
Neutral Engaging
0.3 mm
(0.012 in)
0mmStepped wear of teeth
Usable limitsStandard ValueInspection Item
+0.18
-0.424
- Inspect bearings such as ball bearings and needle bearings for abnormalities in rotation such as
irregularity,hitching,etc. by turning them with pressure applied by hand.Replace defective ones.
- Serious worn or damaged parts should also be replaced.
5-20
To Next Page
Loading...
Need help?
General
