CAUTION
! Before making measurements ensure that the
function selector switch is set on the
appropriate range position.
! Always make sure that the plug of each test
lead is inserted fully into the appropriate
terminal of the meter.
! Ensure that the function selector switch is set
to the “OFF” position after use. When the
meter will not be in use for a long period of
time, place it in storage after removing the
battery.
! Do not expose the meter to direct sunlight,
extreme temperatures or moisture.
! Do not use abrasives or solvents on the meter.
To clean it use a damp cloth and mild
detergent only.
Qualified and trained service technicians should
only perform calibration and repair of the meter.
3. FEATURES
! True RMS measurement of AC Current and
AC Voltage
! Large 4000 count LCD display with bargraph
and a bright white LED backlight.
! Wide measuring range from 0.01A AC up to
1000A AC
! Measures AC and DC Voltage up to 600 volts
! Measures resistance from 0.01Ω up to 40MΩ.
! Capacitance measurements up to 40mF
! Temperature measurement from -40ºC to
+1000ºC and -40ºF to +1832ºF.
! Designed to the international safety standard
IEC61010 CAT lll 600V / CAT ll 1000V,
Pollution degree 2.
! Auto Power Off after approximately 20
minutes to conserve battery life.
! Continuity Buzzer and Diode Test
! Frequency measurement up to 4kHz
! Peak Hold to record the minimum and
maximum readings for current and voltage.
! Data Hold switch used to freeze reading on
display
4
!!
To Next Page
Loading...
Need help?
General
