20
EN
DAB Display Modes
Every time you press the INFO button on the unit or remote control, the display will show the following
display modes:
DLS – Programme Type – Ensemble/Frequency – Signal error/Strength – Bit rate/Codec/Channels
– Date
DLS (Dynamic Label Segment)
This is a scrolling message giving real-time information, e.g. song titles, news headlines, etc.
Programme Type
This describes the "style" or "genre" of the programme that is being broadcast.
Ensemble Name/Frequency
This display the name of the multiplex that contains the station you are listening to and the frequency.
A multiplex is a collection of radio stations that are bundled and transmitted on one frequency. There
are national and local multiplexes. Local ones contain stations that are specic to that area.
Signal Error/ Signal Strength
The error is shown as a number. If the number is 0, it means the signal received is error free and the
signal strength is strong. If the error rate is high, it is recommended to reposition the radio aerial or
reposition the unit. The display will show a slide bar to indicate the signal strength, the stronger the
signal, the longer the bar will be from left to right.
Bit Rate / Codec / Channels
The display will show the digital audio bit rate being received with additional information about the
audio codec and channel conguration.
Date
This displays the current date provided automatically by the broadcaster.
Prune Invalid
You may remove all unavailable stations from the list.
1. While in DAB mode, press the MENU button and press
12
w
/
s
3
buttons to select Prune invalid
and the press SELECT button to conrm.
2. Press
7
/
8
buttons to select [YES] and press the SELECT button to conrm. Or select [NO] to
cancel.
Instructions Guide
To Next Page
Loading...
Need help?
General